Installation plan

Before you begin

Check whether:

  • The device is not bent or damaged.
  • Housing, cabling and all connectors are not damaged.

Set up an installation plan before beginning the installation. Based on the users' needs and capabilities, this plan should take into account:

  • Where which part of the device should be placed.
  • How the device will be operated.
  • A robust and reliable positioning. Hard or sudden movements of the wheelchair may not disorganize the installation.
CAUTION: Make sure that there are no objects or people within the opening range of the arm, to avoid pinching.
Note: Make sure that the wheelchair is in the normal position for the user when you start the installation (so tilt and recline the chair to a normal position for the user).

Step 1: Manual Swing Adapter Set

Attach the Manual Swing Adapter Set to the Manual Swing Pivot Unit.

Step 2: Arm Assembly

The M031-Arm Assembly is composed of several elements, which have to be put together

  1. Remove the plastic cable covers.
  2. Connect the two parts to each other.
  3. Adjust the angle of the Multi Swing 2G arm by loosening the bolt on the inside of the extrusion part. The middle joint can be moved in steps of 15°, the end joint can be moved freely.

Step 3: Preliminary fitting

Now, you can slide the arm into the adapter set. Don't forget to use part C1 at this point, to make sure that the Arm is tight inside the Adapter and that you can tighten it further without causing damage. Locate the pushplate between the Arm and the Adapter on the side of the setscrews. The setscrews should fall in the slots of the pushplate. Align the pushplate with the side of the Adapter.

Check visually how you will place the arm for the end-user.