Installation

Install the USB Charger as follows:
  1. Connect the R-net or DX plug of the charger to the wheelchair R-net or DX socket.
  2. Secure the USB Charger to the wheelchair with screws. Insert the screws at both sides of the unit through the prefitted openings. You may also use double-sided tape or Velcro at the backside of the unit.
  3. Default setting: switch on the R-net or DX interface. A green indicator LED on the unit turns on.
    Note: Continuous setting: the green LED indicator is always on.
  4. Connect the USB cable of the device to the USB Charger.
  5. Guide and secure all cabling on the wheelchair.
    Warning: Protect the device against bumps. Mind damaging the unit and wiring. Make sure that cabling is mounted in such a way that excessive wear and tear is avoided.