R-net configuration

R-net parameters for default settings

Please set the following parameters in R-net before using the Scoot Control:
  • Controls > Global > Power-up Mode: set this parameter to Drive to make sure that you start in the Drive mode when you switch on the Scoot Control.
  • Profile Management > Input Device Type: set this parameter to Attendant and choose No for Allow grab.

See the Curtiss-Wright manual SK77981-14 | R-net Technical Manual for more information.

Using the Scoot Control as Attendant Input Device Type

If the Scoot Control is set as Attendant, then the Scoot Control will always start up in the last used profile.

When you press S6 for more than 2 seconds, the Attendant Profile will grab the focus. You have no access to the modes.

When you press S6 again for longer than 2 seconds, you go back the last used profile and give the focus back to the person in the wheelchair.

By default the parameter Controls > Global > Profile Button is set to Profiles/Modes in R-net.

Note: When you use the Scoot Control as Attendant Input Device Type, the attendant does not have direct access to the modes. If the attendant wants to adjust the lifts of the power chair, you will have to add an external Curtiss-Wright CJSM2 compatible Actuator Keypad (see Actuator Keypad).

Using the Scoot Control as Universal Input Device Type

If the attendant wants access to the modes, then you have to set the Scoot Control as Universal joystick.

To achieve this, proceed as follows:
  • In R-net, set Profile Management > Input Device Type to Universal.
  • Change parameter 5 to Universal: see On-board configuration.
Note: It is very important that you change the settings both in the Scoot Control (on-board configuration) and in R-net. Otherwise the Scoot Control will not function properly.

If the Scoot Control is set as Universal, then the Scoot Control will always start up in the last used profile.

When you press S6 for more than 2 seconds, you scroll through the profiles and the modes. You can drive in every profile and you can change the seating positions.

To change the seating positions with the Scoot Control:
  • Press S6 for more than 2 seconds. You will now scroll through the profiles and the modes. Stop at the seating mode.
  • In the seating mode, you can scroll through the different actuators by pressing the handlebar gently. Stop at the desired actuator.
  • Move the actuator by pushing the left and right throttle (the actuator will move up/down according to the settings of both throttles).

Using the Scoot Control as Universal Input Device Type, but limiting access to the modes

It is possible that you want to use the Scoot Control as a Universal joystick, but you want the user but not the attendant to have access to the seating positions.

In that case, proceed as follows:

  • Make sure that Controls > Global > Profile Button is set to Profiles/Modes in R-net.
  • Change parameter 4 to Profile: see On-board configuration.
Note: It is very important that you change the settings both in the Scoot Control (on-board configuration) and in R-net. Otherwise the Scoot Control will not function properly.